WELCOME TO THE JUNGLE...where you might get a little misty-eyed. The cycle has ended; the coolant is off so WHY is the foam still growing!? With no through-spindle coolant and small ER collets, Grimsmo's got no explanation for the extreme coolant atomization--annoying problem but fun to say!   Saunders notices an off-white tinge occurs sooner than it should but instead of replacing it and shrugging it off, he examines potential root causes. Will sending samples reveal what's really going on? Improving Shop Environment Quality for $200? Yes, please. Saunders has been working to improve shop air quality. Between the Big Ass Fan, the ERV, and the new Fan/Filter Modification from Grimsmo's new lapping machine video, it's like a breath of fresh air. So far, it's working great but whether or not the charcoal filter will clog remains to be seen. Want to get an upgrade? Check out this NYCCNC page for a bill of materials. Double Dose AU Toronto pays Grimsmo a visit to talk Fusion 360. PLUS, the Elliot Matsuura APS Engineer stops by to talk machine tools and custom codes! What makes it Swissish? There's some fuss on WhatsApp about the  Tsugami SS327-5AX Swiss Lathe with B-Axis Pallets? Check. Code? Please wait. Grimsmo wants the code to complete for one pallet, rewind, move over, and start from the stop but there's one BIG problem: Fanuc and it's dinky memory size... Come on, MAN.  It's 2018!  You can't even BUY memory that small anymore!  To make matters worse, logic can't be used in the DNC side of memory which holds 2G (plenty of room).  So, that means 2-3 hours of alone time (hand coding) and the pallets should be good to go.   Tune in to hear about Grimsmo's end of 2018 thoughts AND outlook for 2019!